Phantom products once configured are always available to receive instructions from you and always ready to play. Consequently, it is always warm at the back. There is a possibility to put them on standby and here are the steps to follow:
To put a Phantom on standby mode:
- Make a long press on the back button of your Phantom until the woofers will make a move to show you that it's going on stand by mode. it took around 7 seconds to get this woofer movement.
- Please follow the same steps for each Phantom in your system you want to put them on stand by mode.
Note: Dialog has no stand by mode, to avoid loosing your setup parameters, we recommend you not to unplug the dialog, even if you consider your Dialog being very hot - which is a normal behavior due to its limited ability to dissipate (in view of its size).
To re-activate your Phantom:
- Make a short press on the back button of your Phantom
- Wait a few seconds until the woofers make a mouvement to show that the Phantom is up and running again.
Note: it's preferable to use this step by step for the standby mode rather than unplug your Phantom(s). If you are unplugging regularly your products this might affect your Phantom's installation.
0 Comments